4CELNK-YR OR3V 1.25 Expansion Pack – PNK (2018-027-102-PNK)

The cable areas in the clips for tubing diameters 1.0 inch and above are designed to hold at least 7 typical "SVT" power cords (UL-Type SVT, 3C/18AWG 300V, ~6mm in diameter).

On the OR3V models, the Base Kit has parts to manage cables on both sides of the rig, so expect 12-16 "power cord equivalents" (PCE) total capacity on the rig, front-to-back. Up the thruster mount / mouse platform you'll get about 6-7 PCE.

The 1.25 Expanded Capacity clips have a secondary channel, sized for ~4 16AWG two-conductor speaker cables, in addition to the 8 SVTs on the other side.

"Well yeah, but my cables are HEAVY!" The thing to remember is that no component is ever infinitely strong, nor will anything (besides time itself) last forever. The same is true with 4CELNK-YR clips. There is some large amount of force that will break them. I haven't reached it yet, but it's not at all impossible to yank on a cable and pull it out of the clip. (If you're going to be violently pulling the cables, then maybe stick with tie-wraps)

From what I've been able to tell, "a couple pounds" (~1kg) is just fine as far as holding strength. I might be inclined to add more bands (5-6 instead of 3-4) up to about 5 pounds (2.2 kg), but beyond that weight you should consider adding more clips. A typical "good" straight run of 6+ ethernet cables would normally have a clip about every 3-4 feet (~1 meter) or so, more if the cables need more support.

But, beware: if you put only one clip every 8 feet, and expect it to hold 20 pounds, that will very likely end in disaster...and the warranty won't cover it.

Yes, that's all there is. Snap them on, add bands if you think they'll be needed, then and start adding cables. See the section farther down on how to set the tension using the bands, but often they're not needed.

NOTE: When you do this, the clips may make "crackling" noises, and there might be discoloration of the plastic on the inside edge. This is actually normal for this kind of 3D-printed part.

IMPORTANT: Don't spread the arms out too far! The more you bend them, and the more often you bend them, the more they will lose their "spring" over time. Yes, they can actually be spread quite large and they will "work" afterwards. But, never as well as before being over-stressed.

Please keep the following in mind when using 4CELNK-YR cable clips:

Watch for damaged, worn, frayed or otherwise dangerous cables, and replace all that are unsafe.

Dangling, partially-secured cords beneath desks, tables, and in shelving can in some instances present electrocution and strangling hazards. Be wary!

The 4CELNK-YR arms are closely spaced, and there is spring tension holding them together. Use with care to avoid getting pinched or struck by the arms.

4CELNK-YR Cable Clips are not UL-Listed, they are not specially plenum-rated, nor are they flame-retardant.

4CELNK-YR Cable Clips are not a "safety device".

4CELNK-YR Cable Clips are not specially treated for UV-resistance. Using 4CELNK-YR outdoors, or in a high-UV environment can cause them to age more quickly, and, ultimately, fail sooner.

4CELNK-YR Cable Clips, including the Rack Series, have not been NSF-certified for use in commercial kitchens.

4CELNK-YR cable clips are made from ABS plastic: tough, but not unbreakable. Don't overload the clips.

There may be other hazards associated with your doing with cables whatever it is you're doing. Please always be aware of your surroundings, and be careful.