4CELNK-YR flatBack 9-pc Starter Kit – BLK (2018-027-105)

As with many young products, there are a bunch of detail-level questions where we have to honestly say we just don’t know…yet. One of those is what kind of adhesive is best for the flatBack clips: a dizzying array of choices for a confusing set of applications stands before us at this time.

I've had really good luck with the foam VHB™ tapes (Very High Bond-Strength™, again from 3M). The thin gray stuff seems to work a lot better on these surfaces than the clear, gel-style adhesives. That was the only kind that held well to unfinished, raw plywood. Now I have to figure out how to get it to you.

NOTE: If you're going to get more tape, for reference, the parts are 12.2mm thick, or just under 1/2". I use 1/2" tape despite the overhang. The short clips use 1", and the long clips 2" of tape length. The parts best fit the small and medium Command Adhesive strips, which are quite convenient, but limited in strength.

For now, we chose to include some of those small- and medium-sized 3M™ Command Adhesive strips, one strip per clip, sized as appropriate. At this time there's one extra medium-size strip in the package. Use them to mount the clips to painted and solid surfaces, plastic, metal, and laminate.

One thing to remember is that the Command stips probably will not work very well on unsealed wood surfaces. We’re working on a what to do in that perfectly-normal situation, so check the blog for updates. I’m a big fan of rubberized adhesives, but we’ll see.

The official instructions for this type of Command adhesive can be found at the 3M site: https://www.command.com/3M/en_US/command/how-to-use/all-other-hooks/

If you’ve never used them, it’s important to realize that the Command strips are for “household use”, and are only rated for a few pounds (~1 kg). OTOH, a power-cord typically weighs only about 5 ounces (140 gm). Total. So, be wary, and substitute something stronger if your application needs it. The general steps are:

And yes, I'm PAINFULLY aware those two pieces of paper constitute WASTE. At least from that point there will none from moving wires in and out of the clips.

TIP: When you're adding and removing cables, it's a good idea to hold the clip in place so the force exerted only when adding the cable doesn't become it's undoing.

4CELNK-YR clips are re-usable, so when it’s time, gently pull the command strip off and reuse the clip.

Please keep the following in mind when using 4CELNK-YR cable clips:

Watch for damaged, worn, frayed or otherwise dangerous cables, and replace all that are unsafe.

Dangling, partially-secured cords beneath desks, tables, and in shelving can in some instances present electrocution and strangling hazards. Be wary!

The 4CELNK-YR arms are closely spaced, and there is spring tension holding them together. Use with care to avoid getting pinched or struck by the arms.

4CELNK-YR Cable Clips are not UL-Listed, they are not specially plenum-rated, nor are they flame-retardant.

4CELNK-YR Cable Clips are not a "safety device".

4CELNK-YR Cable Clips are not specially treated for UV-resistance. Using 4CELNK-YR outdoors, or in a high-UV environment can cause them to age more quickly, and, ultimately, fail sooner.

4CELNK-YR Cable Clips, including the Rack Series, have not been NSF-certified for use in commercial kitchens.

4CELNK-YR cable clips are made from ABS plastic: tough, but not unbreakable. Don't overload the clips.

There may be other hazards associated with your doing with cables whatever it is you're doing. Please always be aware of your surroundings, and be careful.